Hudson-robotics Bar Code Print and Apply Manual de usuario descargar pdf (Pagina 16)

Print and Apply User Manual Hudson Robotics, Inc.

C. Hardware Setup

Prior to Label Setup, the hardware must be configured to pick up labels properly. The

apply head can be controlled from the label retrieval or apply head setup screens.

1. Move the apply head out of the way of the air blast.

2. Press the Feed button on the front of the printer to advance one label to

the tear off position.

3. The label should stop right at the edge of the strip bar as seen below.

4. If the label is not in the correct location, it will have to be adjusted

through the printer’s front panel.

5. To get into the submenus, press the (Setup-Exit) button on the front

panel of the printer.

Feed Button

Air Blast

Strip Bar

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

Sin comentarios

Hudson-robotics Bar Code Print and Apply Manual de usuario Pagina 16